UV light is a commonly used method to combat water-borne viruses, bacteria, molds and pathogenic disease-causing microorganisms such as giardia and cryptosporidium.

The proven and reliable UV design shown below has been used successfully for over a decade in residential and light commercial applications where higher quality and budget requirements need to merge.


The key to effective treatment is the exposure of the aforementioned viruses etc. to the UV light.  Other systems installed in hard water areas often foul with limescale impacting the efficiency of the UV lamp.  With a Fluid Dynamics scale prevention unit installed before the UV lamp, fouling is prevented and effective treatment can be expected throughout the life of the UV lamp.

The FD-UV1434 UV system offered by Fluid Dynamics USA comes complete with the following:

  • Power On/Lamp On/Lamp Failure/Lamp Replacement Indicators
  • Long life Stainless Steel (304) housing
  • UV lamp (replace every 12 months)
  • Quartz Sleeve ( replace every 24 months or as required)

Additional detail:

Specifically designed and tested Sterilume TM EX lamps provide consistent ultraviolet
output over the entire life of the lamp (9000 hours) to ensure continuous purification.

The system is simple to maintain and service allowing for easy lamp replacement.

Built with a durable stainless steel chamber to prolong life and eliminate ultraviolet light
degradation.

The controller visually displays the remaining lamp life and will go into alarm if the lamp fails.  Monitored systems are equipped with a UV sensor which provides a continuous readout of UV intensity

The controller has a sealed case to prevent damage from accidental water intrusion ans is fully CSA and CE compliant.

UV 100-240V 50/60Hz, 304SS, 14-34 GPM, 1″ MPT/3/4″ FPT, Chamber ~3.5″D x 23.5″L/Controller ~7.25″ x 3.25″ x 2.5″, ~18 GPM at 30 mJ/cm2 @ 95% UVT,
Power On/Lamp On/Lamp Failure/Lamp Replacement Indicators, (VH410)